how to apply wood fence panels to existing chain link wrap a metal fence bracket around one of the metal posts on your chain link fence, lay a 2-by-4 or 2-by-6 board horizontally over the flat portion of the bracket, continue securing horizontal boards at the top and bottom of each post.
a wooden trellis fence provides more privacy and beauty than that of a chain link fence. you can add sturdy but lightweight wooden or composite lattice or trellis panels to the front of an existing sturdy chain link fence to create your own privacy barrier.
how to attach a privacy fence to a chain link fence lay scrap two-by-four boards on the ground at the base of the chain link fence to serve as hold a 4- to 6-foot-wide roll of bamboo or cane fence cladding upright at one end secure the cladding to the end fence posts with 12-inch lengths of
if it is a chain link fence; you can add 'slats' to weave them in the chain link holes to create a privacy fence - they sell them pretty cheap in pvc version in decent colors. they also make a black like fabric that you can tie onto the fence that is often used in city construction projects to block view. hope this helps
with the assistance of another adult, remove the top rail from the fence. next, remove the brackets that hold the chain link to your fence. you may need to uncoil wire that has been wrapped around the fence support poles. once you've done this, pull the chain-link fence away from the posts and set it aside.
the only other thing i can recommend, if you have some lengths of 2x6 or something like that to place at the bottom of the fence, so they don't start digging under the fence to try to get to the other side. lean it against the fence, and stake it in place temporarily bundle of stakes from seven trusts it probably <$10,
my husband had used wood poles between each section of fence and then nailed a board between each pole at the top and bottom of each section, we took nylon webbing, the kind used to replace the worn out webbing in the older type lawn chairs, and wove it in and out of the chain link.
wood fence on galvanized poles can look pretty sharp. i would encourage you to buy the lumber and build out the fence. the pre-made panels just dont seem to hold up very well. id be a little bit apprehensive about the 10' span. but if the bottom of the fence is against the ground not recommended then it wouldnt really be an issue.
attach the wood fence to the vertical bar with the help of brackets. it is an added benefit to stabilize the wooden fence to the chain link fence, but the wooden structure that you build should be able to stand alone if you ever wanted to remove the chain link fence.
there are special brackets you can buy that allow you to attach the panels to the posts. one problem may be spacing though, since most chain link posts are 10 ft apart, and most wood panels are 8 feet, you might have to add 2 x 4 bracing to tie the panels together along the two horizontal rails.
wrap the wire in between the lattice and chain link fence in the middle of the panel, then twist the wire to make sure it is secured to the panel. next, use pliers to cut off the extra wire. repeat this on the edges to the left and right, then on the top and bottom.
next, add the remaining three cross pieces to the end of the middle panel and connect the third fence panel. once you line up your back fence panel with the last steel post, connect the panel to the post using the tension band method from step four.
the simplest and albeit, the easiest way to attach privacy material to your chain link fence is to use the 2 inch wide redwood lath or the privacy inserts. these inserts can go in vertically or diagonally and are easy to install. the fence weave kit comes complete with brass fasteners.