several small refinements to the manipulator arms of these units, such as reconfigured joints, use of higher tensile strength metals in construction, and a software upgrade, add up to a substantial improvement in the production and repair rates of these units. a redesign of the panther using a new composite alloy has increased the
-gnome- description a spear protected by gnome, the manifestation of the second fonon. stat boosts p, atk 100 f. atk 600 a. atr earth note can be bought at the casino for 20,000 chips. -deck brush- description scrub, ya scurvy swab! scrub! make the deck shine! stat boosts p. atk 200 f. atk 10 note found in a closet in tear's house.
reason we cope rather than miter long runs of moulding on the inside joints. lengthwise movement is 1% or less, but over a 10-20 ft run it’s noticeable and a factor you can work with if you choose to. deck tolerances are generally crude. do whatever is convenient for you and live with. high end work for clients is a different situation.
we trim most of the composite decks we build with picture-frame borders, in a color that contrasts with the field decking. at the corners of such borders, many deck builders simply cut miter joints, and while these look good at first, they don’t look good for long.
after the short scene a party chat opens up: party chat - a glamorous life ¯¯¯¯¯¯¯¯¯¯ watch the scenes as you enter and you'll realize this is a "town", not a dungeon. anyway move to the southeast corner of the area (upper deck) and examine the crates to find [antartic wind].
on my decks, i assume nature is going to win out over mechanics, and i design joints to allow for movement. i leave a gap at the joints, and i “pillow” the edges of the miter (figure 2). by pillow, i mean rout the cut edge with the same radius as on the rest of the decking. this radius is normally somewhere between 1/4 inch and 1/8 inch.
composite deck mitre joints movement in mitered corners professional deck builder magazine 1 mar 2010 lavrans mathiesen, a woodworker and deck builder in portland, ore., responds: miters open because the material moves.
re: installing composite decking in patterns with hidden fasteners if you do the miter joint corner, you should pillow joint (small round over on the end of each miter) them. with the length of yours gap them as others have pointed out. take a look at a basket weave before you cut them, you may like that look better.