use pliers to fold the tie around one wire of the chain link fabric. repeat this with the other end of the chain link tie, folding it around another wire in the fabric. do this for each tie. the tighter you wrap the tie and fold it over, the more secure and taut the chain link fabric will be.
fasten the panel to the chain link by wrapping tie wire through the lattice and around the chain link. tighten and snip the excess wire with your pliers. step 3
rachel first laid two cedar planks on the ground horizontally, separated so that outer edge to outer edge measured roughly four inches taller than the height of the existing chain-link fence
the process was similar to when i converted a chainlink fence to a wood fence, except in this case, we left the chainlink fence intact. this method is a good option if you want to add a little more privacy to your yard or camouflage a chainlink fence while you wait to save up for a completely new fence.
can i attach privacy fence panels to an existing chain link fence? will it support the weight? fence is needed in a hurry so i don't want to have to take down the old fence and dig new holes.
if your posts are not sufficient, then you will need to set new posts, either with concrete or the alternative post anchor installation method discussed in solution 2. issue 4. if you are installing privacy fence, chances are you are looking to convert a 4 foot chain link fence to a 5 or 6 foot wood fence.
chain-link fence can also be attached to wooden posts and rails. in those cases, no end caps, loop caps or rail caps are used. if the ground slopes up or down at your gate's location, set the gate posts to follow the grade. to provide privacy with a chain link fence, thread thin, flexible wooden or plastic slats diagonally through the mesh.
replaced old chain link fence with wooden fence using existing poles. skip navigation sign in. search. loading close. this video is unavailable. sign in to add this to watch later
how to put a wood fence on chain link posts step 1: check existing posts. before you go through the time and energy step 2: determine height. the height of your fence will determine the number step 3: install the fence. once you have the height and the number of runners needed, step 4:
next, secure each edge of the wire mesh using a fencing staple. then, secure along the whole vertical edge, adding a staple at 6-inch intervals. you'll then need to unroll the fabric until you get to your next vertical or corner post. using a fence stretcher, make the mesh as tight as possible.
attach the fabric to the posts with fence ties about every 12 inches, and along the top rail every 24 inches. along the bottom, secure the fence to the tension wire with wire clips.
attach a 1-by-4-inch board 4 feet long on the trellis side and one on the chain link side of the fence using wood or deck screws to join the two boards. this will help secure your fence, especially in windy areas. attach boards at the top of the fence and at the bottom, covering the edges of the lattice panels.
unlike its wooden counterparts, a chain link gate isnt likely to sag over time. when building your own gate, first fit the frame together, then attach the mesh by slipping tension bars into the tension bands. standard tie wires hold the mesh at the top and bottom. metal hinge pins hold the gate in place,
attach a 1-by-4-inch board that is approximately 4 feet long on the trellis side, then add another one on the chain link side. then, use deck or wood screws to join the two boards to secure the fence for the long term.
use wood screws on both sides to the fence pole to attach the first panel. attach the wood fence to the vertical bar with the help of brackets. it is an added benefit to stabilize the wooden fence to the chain link fence, but the wooden structure that you build should be able to stand alone if you ever wanted to remove the chain link fence.