however, you will find that it is all worth it in the end whenever you have a strong and sturdy stockade fence surrounding your yard. step 1 set up posts. you will begin by getting your posts set up an equal distance away from each other. you will need to get posts that are 4 by 4 inches. the corner posts that you use should be 6 by 6 inches.
after anchoring posts with brackets, builders construct the fence as normal, attaching fence rails and fence boards. step 1 stretch a chalk snap line across the slab to mark a line that indicates the outer faces of the fence's posts; do not position the snap line to indicate the posts' center line.
how to install a stockade fence mark the area for the fence with a string line, inserting a wooden stake in each corner for mark the location for each fence post so that the distance between each 4-by-4-inch fence post is dig a hole for each fence post, measuring 24 to 30 inches deep and
brace band - a strip of metal shaped to fit around a post and used with a carriage bolt and nut to attach the rail end to the post. also used for fence tie - ties that are used in chain link fencing to attach the fence to the line posts.
the end posts should measure 6 feet from the outside edge of the fence post to the center of the nearest post in the line. tie a string around one of the end or corner posts and pull the string tight to the opposite end or corner post, setting the string at the desired height for the fence.
how to mark a fence line and the post locations before building a fence. after digging the post holes, the posts should be braced and set in concrete before attaching the rails and pickets.
cover the horizontal boards near one end of the fence with a wood fence panel, and secure 1.5-inch screws through the panel and into the horizontal boards, using a drill. secure the panel to the boards at the top and bottom, and also to the middle board, if you've installed one.
landscaping should i attach the fence post s where my fence is the best thing to do still to dig the standard hole and set the fence post in there, or should end posts at the house actually be if they are attached to the siding, should i still dig a hole or should the entire post be attached to the house? .
how to install a fence post. this is how to install a fence post a real easy and strong way that will last for years. if your building a fence or repairing a gate post, this video is sure to help
tamp down the gravel using the bottom of the fence post. to do this, set the post in the hole and, with gloved hands, lift the post up a few inches and bring it back down hard on the gravel. repeat this three to five times to even out the gravel. position the post in the center of the hole and hold it upright.
the sawn-off ends of the fence post are vulnerable to moisture. consider these precautions if you live in a damp climate: bevel the top of the fence post to a 45º angle to encourage rain runoff, or plan on installing a post cap. treat the two ends with a non-water-based, brush-on wood preservative, such as copper naphthenate.
you can repair a stockade fence or a privacy fence by adding posts permanently to each side of the damaged post. dig the holes for the new posts so that the posts will touch the cross bars of the fence when vertical. put several inches of gravel in the bottom of the hole, add cement and let it cure completely.
sometimes a wood fence itself isnt enough for your needs. if your wood fence is made up of posts and rails, then it wont keep out animals and other pests effectively. to remedy that, the simplest solution is to add wire to your wooden fence. its not a complex job, especially if you know the
if you really want to do this, i think jon1270/bonobothegreat's suggestion of attaching the new posts to the side of the old ones with carriage bolts is best. but yeah, wind load plus the sheer weight of an 8ft wood fence is going to want to pull those existing poles over or break them.
no you don't put the sections between the posts, you land them centered on the posts. if you are buying pre assembled stockade sections just attach them to the posts. you are waaaaay overthinking this. for all the time spent hand wringing about it, you could have built the fence several times over.
adding new life to an old fence with this old house landscape contractor roger cook. see below for a shopping list and tools. subscribe to this old house: